| Size : 18.25” (465mm) tall / 12.25” (312mm) wide / 12.63” (321mm) deep
Weight : 18 lbs (8.2kg)
Power: 115 VAC 60 Hz at .6 amps, 65 watts typical
Beverage cans must be between 3.5 to 5.375 inches (89 to 136mm) tall and 2 to 2.6 inches (51 to 66mm) in diameter.
An ambient temperature range of 50 to 80°F (10 to 27°C) will provide good performance.
Requires 4-inch (102mm) clearance behind the vending machine.
Maintenance of the Vending Machine
Periodically you will need to remove, clean and dry the tray where the cans fall onto when dispensed. This will require more frequent attention in humid conditions. High humidity will also cause condensation inside the unit that should be wiped up with a dry cloth. When cleaning, turn off the power switch and disconnect the power cord. Vacuum out the ventilation grills on the back of the unit. Use only a damp warm cloth and a mild detergent for cleaning. Avoid the use of harsh cleaning agents and solvents. If storing the Vending Machine please switch off the power, disconnect the power cord, then clean and dry it thoroughly.
How to operate the Vending Machine
Choose an indoor location for the Vending Machine that is not too close to heat, sunlight, wet or humid conditions. Keep out of reach of small children.
Position the Vending Machine Fridge no closer than 4 inches from walls to ensure adequate air circulation through the ventilation grills on the back side of the unit.
Choose a location within 6 feet of a wall outlet to avoid use of an extension cord; if an extension cord is required be sure to choose an UL approved cord that is as short as possible. Plug power cord into the socket on the cooler and the wall outlet. Always push or pull on the plugs, not on the cord itself to avoid damage. Do not place the power cord under heavy objects to avoid damage. Replace any damaged power cord. Slide the POWER switch to the ON position. The power indicator light will illuminate and the cooling system will start.
Press button on the left side to open the cooling compartment. Fill the dispensing sections with cans, and place additional cans into the prechilling section between the dispensing sections but do not block the fan opening. This Koolatron Vending Machine unit can hold ten 12oz. beverage cans, with four (4) cans in each of two separate dispensing sections, and two (2) additional cans in a prechilling section. Smaller cans can also be used, but test for correct operation first. It will take several hours to cool cans down from ambient temperature, please allow up to 8 hours.
Open the display window from the right side and install display cans on the two suction cups to match the contents of the dispensing sections inside. Wetting the suction cups will provide better grip, but deformed cans and paper labels will reduce the grip. When removing the display cans, carefully peel the suction cup from the can.
To dispense a beverage press lighted buttons located on the front of the Vending Machine under the display window. Please ensure the door is closed when dispensing to avoid damage or injury.
|
